Waterproof Tablet Case

Never expose your case to extreme heat, like leaving your case on a car dashboard as it could potentially melt at temperatures above 45 degrees. Do not submerge in hot pools, spas, baths or hot springs that are above 45 degrees. Extreme temperatures could cause your case to leak and electronics don’t like extreme heat. In humid conditions or hot climates, we recommend inserting a silica gel sachet, which will soak up any condensation trapped inside the case. While the case can withstand high temperatures, the case can not protect anything inside it from heat or sunlight.

Some phones will float and some won’t depending on how much air is trapped in the case. Always test that your phone floats in shallow water, never assume that it will float. A float or foam can be added to make the case float.

Capacitive touch screens don’t work underwater, as water disrupts the connection. For underwater photos either start the video on the surface or use side buttons to operate your camera. Fingerprint recognition won’t work on all phones and you may have to enter your password.

• Always inspect your case for potential faults, excessive wear or accidental damage before every use. If in doubt do not use and replace.
• Check that the locking closure is completely free of sand, salt, dirt,dust and debris that may interfere with the waterproof seal. Rinse with fresh water if necessary.

Volare 100% Waterproof Cases

In order for this Volare® case to be 100% waterproof, it must be sealed as per the following instructions.

 Use:

Before every use we recommend you perform an initial waterproof test.

Closing the Case

Step 1: Before every use place a tissue inside and close the sliders firmly to the locked position.

• Submerge the case in water so that it is completely covered.
• Bubbles will initially escape from the clip and then stop.
• Squeeze the case softly, you should not see a constant stream of bubbles. If this does occur do not use the case.
• Completely dry case before reopening.

Step 2: Insert your device, ensure it is the correct size and not overly tight.

Step 3: Firmly secure the sliders into the locked position.

 Opening the Case:

Never open in or underwater. Dry the case before opening and hold case so the clip is facing the ground. This will ensure any water drops that may be in the clip will fall away from the case and your device.

Our warranty covers the Volare case only and does not cover any items you may put inside it. We recommend that you insure contents separately. We offer a no fuss 12 months warranty against case defects and should you in testing discover a defect we will happily replace the case at no cost.